Kia Cee'd: Engine Control System / Heated Oxygen Sensor (HO2S) Description and operation

Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance with the air/fuel ratio.

The sensor must be hot in order to operate normally. To keep it hot, the sensor has a heater which is controlled by the ECM via a duty cycle signal. When the exhaust gas temperature is lower than the specified value, the heater warms the sensor tip.

Knock Sensor (KS) Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold. (Re ...

Heated Oxygen Sensor (HO2S) Specifications

Specification HO2S [Bank 1/Sensor 1]   Item Specification Heater Resistance (Ω) 2.4 ~ 4.0 [20°C(68°F)] ...

Other information:

Kia Cee'd JD Service Manual: Rear Washer Switch Repair procedures
Inspection Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. Rear Wiper Switch Rear Washer Switch ...

: What Is the Tire Sealant and Inflator Kit. Tire Sealant and Inflator Kit Precautions. Locating the Tire Sealant and Inflator Kit
What Is the Tire Sealant and Inflator Kit The kit consists of an air compressor to re-inflate the tire and a canister of sealing compound that will effectively seal most punctures. This kit will provide a temporary tire repair allowing you to drive your vehicle up to 120 mi (200 km) at a maximu ...