The hazard warning flasher should be used whenever you find it necessary to stop the vehicle in a hazardous location. When you must make such an emergency stop, always pull off the road as far as possible.
The hazard warning lights are turned on by pushing in the hazard switch. Both turn signal lights will blink. The hazard warning lights will operate even though the key is not in the ignition switch. To turn the hazard warning lights off, push the switch again.
Kia Cee'd JD Service Manual: Variable Intake Solenoid (VIS) Valve Description and operation
Description
Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold.
The VIS valve controls the vacuum modulator which activates a valve in the intake
manifold. The ECM opens or closes this valve according to engine condition (Refer
to below table). ...
Kia Cee'd JD Service Manual: TPMS Receiver Schematic diagrams
Circuit Diagram
Hamess Connector
Pin No.
Discription
1
Battery ECU
2
Ignition ON
3
CAN_HIGH
4
CAN_LOW
...