Kia Cee'd: Fuel Delivery System / Fuel Pump Repair procedures

Inspection
[Fuel pump]
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump assembly.
3.
Check motor operation by fuel pump connector (A) connecting power (No.4) and ground (No.5).

 
Pin No.
Description
1
Fuel sender signal
2
 - 
3
Fuel sender ground
4
-
5
Fuel pump motor (+)
6
Fuel pump motor (-)

[Fuel sender]
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump assembly.
3.
Using an ohmmeter, measure the resistance between terminals 1 and 3 of sender connector (A) at each float level.

 
Pin No.
Description
1
Fuel sender signal
2
 - 
3
Fuel sender ground
4
-
5
Fuel pump motor (+)
6
Fuel pump motor (-)

4.
Also check that the resistance changes smoothly when the float is moved from "E" to "F".
 
Position
Resistance(Ω)
Capacity (ℓ)
E
197 ~ 203
3.7
 1/2
64.2 ~ 68.2
26.7
Sender (F)
6 ~ 10
52.6

Removal
1.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
2.
Remove the fuel pump service cover (A) after loosening the screws (B).

3.
Disconnect the fuel pump connector (A).
4.
Disconnect the fuel feed tube quick connector (B) and the vapor tube quick-connector (C).
5.
Remove the fuel pump plate cover (D) after removing the bolts.
6.
Remove the fuel pump from the fuel tank.

Installation
1.
Installation is reverse of removal.
  
Be careful of fuel pump direction (Refer to the groove in the fuel tank).
Fuel pump plate cover installation bolt :
2.0 ~ 2.9 N.m (0.2 ~ 0.3 kgf.m, 1.4 ~ 2.2 lb-ft)
Fuel Tank Repair procedures
Removal 1. Release the residual pressure in the fuel line. (Refer to Fuel Delivery System - "Release Pressure in Fuel Line") 2. ...

Fuel Filter Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the electric pump & sender ...

Other information:

: Checking the Coolant
When the engine is cold, check the concentration and level of the coolant at the intervals listed in the scheduled maintenance information. Note: Make sure that the coolant level is between the minimum and maximum marks on the coolant reservoir. Note: Coolant expands when it is hot. The level ...

Kia Cee'd JD Service Manual: Rear Seat Cushion Cover Components and components location
Component Location   1. Rear seat cushion cover [LH] 2. Rear seat cushion cover [RH] ...

© 2017-2026 www.kceed.com