Kia Cee'd: Fuel Delivery System / Fuel Line Repair procedures

Removal

1.	Turn the ignition switch OFF, and then remove battery (-) cable.

2.	Release the residual pressure in fuel line. (Reter to Fuel Delivery System - "Release Residual Pressure in Fuel Line")

3.	Disconnect the low pressure fuel quick-connector (A).

4.	Disconnect the vapor hose (A) which is connected from the PCSV.

5.	Disconnect the fuel feed quick-connector (A) freom the fuel pump.

6.	Lift the vehicle.

7.	Disconnect the vapor tube quick-connector (A).

8.	Open the vapor tube line fixing clip (A) to using driver.

9.	Open the fuel feed line fixing clip (A) to using driver.

10.	Disconnect the fuel & brake line protect (A) from the fixing clip.

11.	Disconnect the fuel feed line fixing clip (A) from engine room lower.

12.	Remove the fuel line (A).

Installation

•	Do not use already used injector fixing clip again.

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

1.	Installation is reverse of removal.

Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the electric pump & sender ...

Removal 1. Lift the vehicle. 2. Disconnect the fuel filler hose (A), leveling hose (B) and the ventilation hose (C). ...

Kia Cee'd JD Service Manual: Hands Free Switch Repair procedures
Inspection Type A 1. Check the audio remote control switch (A) for resistance between connector 3 and 4 in each switch position. [Audio] Switch Connector terminal ...

Kia Cee'd JD Service Manual: Components and components location
Component Location 1. Rear glass defogger switch (A/C controller) 2. Rear glass defogger 3. Rear glass defogger relay ...