Kia Cee'd: Lighting System / Front Fog Lamps Repair procedures

Inspection

1.	Disconnect the negative (-) battery terminal.

2.	Remove the lighting switch of the multifunction switch. (Refer to Multifunction Switch)

3.	With the front fog lamp switch, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch. Fog Lamp

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front bumper cover. (Refer to Body - "Front Bumper Cover")

3.	Remove the front fog lamp connector (A) from the front bumper.

4.	Remove the front fog bulb (A) after turning it counterclockwise.

5.	Remove the front fog lamp assembly (A) after loosening 4 screws.

Installation

1.	Install the front fog bulb and connect the connect.

2.	Install the front fog lamp assembly.

3.	Install the front bumper cover.

Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash P ...

Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the lighting switch of the multifunction switch. (Refer t ...

Kia Cee'd JD Service Manual: ICM (Integrated Circuit Module) Relay Box Repair procedures
Inspection 1. The ICM (Integrated Circuit Module) can be diagnosed by using the GDS more quickly. The BCM communicates with the GDS and then reads the relay value and drives the actuator. 2. To diagnose the ICM relay ...

Kia Cee'd JD Service Manual: Rail Pressure Sensor (RPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. Condition Output Voltage (V) ...