Kia Cee'd: Front Bumper / Front Bumper Cover Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Cover Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Pull out the head lamp washer nozzle outward.

2.	Then remove the head lamp washer nozzle cover (A) by widening both lock pins (B) outward using two gimlets.

3.	Loosen the radiator upper cover (A) mounting clips.

4.	Loosen the front bumper lower mounting clips.

5.	After loosening the front bumper side's mounting screw, then disconnect the side's.

6.	Disconnect the fog lamp connector (A) and front parking assist sensor connector (B). [LH] [RH]

7.	Remove the front bumper cover (A).

Install in the reverse order of removal.

•	Replace any damaged clips.

•	Make sure the connector is plugged in properly.

Front Bumper Cover Components and components location

Component Location 1. Front bumper cover ...

Radiator Grill Components and components location

Component Location 1. Radiator grill ...

Other information:

: Federal Highway Administration Regulation
Regulations such as those issued by the Federal Highway Administration or issued pursuant to the Occupational Safety and Health Act (OSHA), and state and local laws and regulations may require additional equipment for the way you intend to use your vehicle. It is the responsibility of the reg ...

Kia Cee'd JD Owners Manual: Auto stop indicator
This indicator will illuminate when the engine enters the Idle Stop mode of the ISG (Idle Stop and Go) system. When the automatic starting occurrs, the auto stop indicator on the cluster will blink for 5 seconds. For more details, refer to the ISG (Idle Stop and Go) system in chapter 5 ...