Kia Cee'd: Fuel Delivery System / Filler-Neck Assembly Repair procedures

Kia Cee'd JD Service Manual / Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures

Removal

1.	Lift the vehicle.

2.	Disconnect the fuel filler hose (A), leveling hose (B) and the ventilation hose (C).

3.	Open the fuel filler door and then remove the filler-neck installation screw (A).

4.	Remove the rear-LH wheel, tire, and the inner wheel house (A).

5.	Remove the filler-neck assembly from the vehicle after removing the bracket installation bolt (A).

Installation

Installation is reverse of removal.

Filler-neck assembly bracket installation bolt :

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Filler-neck assembly installation screw :

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Fuel Line Repair procedures

Removal 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Release the residual pressure in fuel line. ( ...

Accelerator Pedal Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sens ...

Other information:

Kia Cee'd JD Service Manual: Specifications
Specifications Purge Control Solenoid Valve (PCSV) ▷ Specification Item Specification Coil Resistance (Ω) 22.0 ~ 26.0 [20°C(68°F)] Tightening Torques Item ...

Kia Cee'd JD Service Manual: Repair procedures
Inspection [System Inspection] 1. Disconnect the vapor hose from the throttle body and connect a vacuum pump to the nipple on the throttle body. 2. Check the following points with applied vacuum using a vacuum pump. ...