Kia Cee'd: ESP(Electronic Stability Program) System / ESP OFF Switch Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad center lower panel.
(Refer to Crash Pad - "Crash Pad Center Panel")
3.
Remove the center facia switch assembly (A) after loosening screws.

4.
Check the continuity between the switch terminals as the ESP OFF switch is engaged.

ESP OFF Switch Description and operation
Description • 1st stage The ESP engine control function will stop when the ESP OFF indicator on the cluster turns on by pressing the ESP OFF button for ...

Steering Angle Sensor Description and operation
Description The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to ...

Other information:

Kia Cee'd JD Owners Manual: Speed limiter indicator
The indicator illuminates when the speed limit control system is enabled by move the lever up on the steering wheel. The indicator goes off when the lever up again to deactivate the system. If there is a problem with the speed limit control system, the “---” indicator will blin ...

Kia Cee'd JD Owners Manual: Hazard warning flasher
The hazard warning flasher should be used whenever you find it necessary to stop the vehicle in a hazardous location. When you must make such an emergency stop, always pull off the road as far as possible. The hazard warning lights are turned on by pushing in the hazard switch. Both ...

© 2017-2022 www.kceed.com