| Remove |
| 1. |
Turn ignition OFF and disconnect the negative (-) battery cable.
|
| 2. |
Remove the floor console upper cover.
(Refer to Body - "Floor console assembly")
|
| 3. |
Remove the EPB switch assembly after loosening the screws.
|
| 4. |
Install in the reverse order of removal.
|
Electronic Parking Brake (EPB) Repair proceduresKia Cee'd JD Service Manual: Rail Pressure Sensor (RPS) Description and operation
Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the
instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor
element) built in the sensor converts the pressure to voltage signal. By using
this signal, the ECM ...
: Pre-Collision Assist Precautions. Pre-Collision Assist Limitations
Pre-Collision Assist Precautions
WARNING: You are responsible for
controlling your vehicle at all times. The
system is designed to be an aid and does
not relieve you of your responsibility to
drive with due care and attention. Failure
to follow this instruction could result in
the loss of cont ...