Kia Cee'd: Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Kia Cee'd JD Service Manual / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Inspection
1.
Check signal waveform of CKPS and CMPS using a GDS.
Specification: Refer to “Waveform”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt.

Installation
  
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  
Apply the engine oil to the O-ring.
  
Insert the sensor in the installation hole and be careful not to damage.
1.
Installation is reverse of removal.
Crankshaft position sensor installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Crankshaft Position Sensor (CKPS) Schematic diagrams
Circuit Diagram [NON-ISG] [ISG] ...

Camshaft Position Sensor (CMPS) Description and operation
Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and ...

Other information:

Kia Cee'd JD Service Manual: Repair procedures
Replacement [5Door]    • Put on gloves to protect your hands.    • ...

Kia Cee'd JD Owners Manual: Vehicles without smart key system
With the immobilizer system, whenever you insert your ignition key into the ignition switch and turn it to ON, it checks and determines and verifies if the ignition key is valid or not. If the key is valid, the engine will start. If the key is invalid, the engine will not start. To dea ...

© 2017-2023 www.kceed.com