Kia Cee'd: Manual Transaxle Control System / Control Cable Repair procedures

Kia Cee'd JD Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Cable Repair procedures

Removal

1.	Move the shift lever to 4th gear.

2.	Remove the air duct and the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")

3.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

Remove the control cable.

(1)	Remove the control cable from the control shaft after removing the snap pins (A).

(2)	Remove the control cable (B) from the bracket (C).

5.	Remove the gear boots (A) and then remove the shift lever knob (B) by rotating counter-clockwise.

6.	Remove the floor console assembly. (Refer to Body - " Floor Console")

7.	Remove the select cable (A) from the shift lever after removing the snap pin.

8.	Remove the shift cable (B) after removing the clip (A).

9.	Remove the cable sockets (A) from the shift lever.

10.	Remove the crash pad and cowl cross bar. (Refer to Body - "Cowl Cross Bar Assembly")

11.	Remove the heater unit. (Refer to Heating,Ventilation, Air Conditioning - "Heater Unit")

12.	Remove the retainer (A) after loosen the nut (B).

13.	Remove the control cable into the cabin room side.

Installation

Install the cable retainer (A).

Tightening torque :

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

2.	Install the heater unit. (Refer to Heating,Ventilation, Air Conditioning - "Heater Unit")

3.	Install the crash pad and cowl cross bar. (Refer to Body - "Cowl Cross Bar Assembly")

4.	Install the control cable soket (A).

5.	Install the shift cable ( B) to the shift lever after intalling the snap pin (A).

6.	Insert the snap pin after installing the select cable (A) to the shift lever.

7.	Install the floor console assembly. (Refer to Body - "Floor Console")

8.	Install the boots (A) to the console after Installing the knob (B) by rotating clockwise.

Install the control cable.

(1)	Check that the shift lever and control shaft are placed in the "4th" position.

(2)	Install the control cable to the cable bracket.

(3)	After pulling the holder (A) in the direction of the "P", pull the lock (B) in the direction of the "F".

(4)	Push the lock (C) after installing the control cable to the control shaft.

(5)	Insert the snap pin (A).

10.	Install the battery and battery tray. (Refer to Engine Electrical System - "Battery")

11.	Install the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")

Control Cable Components and components location

Components 1. Knob & Boots 2. Shift lever assembly 3. Shift cable 4. Select cable 5. Control cable retainer ...

Control Shaft Complete Components and components location

Components Location 1. Control Shaft Complete ...

Other information:

Kia Cee'd JD Service Manual: Special service tools
Special Service Tools Tool(Number and Name) Illustration Use 09581-11000 Piston expander Spreading the front and rear disc brake piston. 09580-0U000 Brake piston adju ...

Kia Cee'd JD Owners Manual: Sound Settings
Audio Settings Press the key Select [Sound] Select [Audio Settings] Use the , , , buttons to adjust the Fader/Balance settings. Use the , buttons to adjust the Bass/Middle/Treble settings. Press the button to reset. SDVC (Speed Dependent Volume Control) Press the key Select ...