Kia Cee'd: Dual Clutch Transmission Control System / Clutch Actuator Motor 1 (Odd Gear) Repair procedures

Inspection
1.
Turn off the ignition switch.
2.
Disconnect the clutch motor connector (A).

3.
Measure the resistance on the clutch motor terminal.
4.
Refer to the specifications and check that the measured resistance is as specified.
(Refer to Clutch Actuator Motor 1 - "Specification")
Removal
1.
Turn off the ignition switch and then disconnect the battery (-) cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
3.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
4.
Remove the ECM.
(Refer to Fuel System - "Engine Control Module (ECM)")
5.
Disconnect the clutch actuator motor connector (A).

6.
Loosen the mounting screw, and then remove the clutch actuator motor (A).
Tightening Torque :
4.4 ~ 5.4 N.m (0.45 ~ 0.55 kgf.m, 3.3 ~ 4.0 lb-ft)

Installation
1.
Install in the reverse order of removal.
  
Clutch actuator spline (A) with grease before installation.
Specified grease [CSG-101M (0.1ml)]

Clutch Actuator Motor 1 (Odd Gear) Schematic diagrams
Schematic Diagrams ...

Clutch Actuator Motor 2 (Even Gear) Description and operation
Description The clutch actuator motor is mounted on the Dual Clutch Transmission(DCT). The clutch actuator motor comprises an actuator motor that controls the odd clutch and a ...

Other information:

Kia Cee'd JD Service Manual: Components and components location
Components [5Door]   1. Rear bumper cover 2. Rear bumper side bracket [RH] 3. Rear bumper side bracket [LH] 4. Rear bumper under cover Components (2) [3Door]   1. Rear bumper cov ...

Kia Cee'd JD Owners Manual: Seat
Driver’s seat (1) Seat adjustment, forward/backward (2) Seatback recliner (3) Seat adjustment, height (4) Lumber support* (5) Seat warmer* (6) Headrest adjustment (7) Walk-in seat (for 3 door vehicle only) Front passenger seat (8) Seat adjustment, forward/backward (9) Seatback reclin ...

© 2017-2025 www.kceed.com