Kia Cee'd: Engine Control System / Camshaft Position Sensor (CMPS) Repair procedures
1. |
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
|
|
• |
DON’T remove the camshaft position sensor while the engine is
running or right after engine is turned off. The part and engine
oil is hot and can cause burns.
|
|
1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
|
2. |
Disconnect the camshaft position sensor connector (A).
|
3. |
Remove the installation bolt (B), and then remove the sensor.
[Bank 1 / Intake]
![](images/camshaft_position_sensor_cmps_repair_procedures-966/752/smdfl1049d.gif)
[Bank 1 / Exhaust]
![](images/camshaft_position_sensor_cmps_repair_procedures-966/752/smdfl1050d.gif)
|
• |
Install the component with the specified torques.
|
• |
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
|
|
• |
Apply the engine oil to the O-ring.
|
|
• |
Insert the sensor in the installation hole and be careful not
to damage.
|
|
• |
Be careful not to damage the sensor housing and the connector.
|
• |
Be careful not to damage the O-ring.
|
|
1. |
Installation is reverse of removal.
Camshaft position sensor installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
Description
Knocking is a phenomenon characterized by undesirable vibration and noise and
can cause engine damage. Knock Sensor (KS) is installed on the cylinder block
and senses ...
Other information:
Kia Cee'd JD Owners Manual: Anti-lock brake system
(ABS) warning light
This light illuminates if the ignition switch
is turned ON and goes off in approximately
3 seconds if the system is operating
normally.
If the ABS warning light remains on,
comes on while driving, or does not
come on when the ignition switch is
turned to the ON position, this indicate ...
Kia Cee'd JD Owners Manual: To use the cargo security screen
1. Pull the cargo security screen towards
the rear of the vehicle by the handle
(1).
2. Insert the guide pin into the guide (2).
✽ NOTICE
Pull out the cargo security screen with
the handle in the center to prevent the
guide pin from falling out of the guide.
When the cargo security s ...