Kia Cee'd: Blower / Blower Unit Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater & blower assembly.
(Refer to Heater - "Heater Unit")
3.
Separate the blower unit from the heater unit after loosening the screws.

  
Make sure that there is no air leaking out of the blower and duct joints.
4.
Install in the reverse order of removal.
Blower Unit Components and components location
Component Location Components   1. Intake Seal 2. Intake Upper Case 3. Intake Actuator 4. Climate control air filter 5. Climate control ...

Blower Motor Repair procedures
Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, ...

Other information:

Kia Cee'd JD Service Manual: Engine And Transmission Assembly Repair procedures
Removal    • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while ...

Kia Cee'd JD Owners Manual: Multi fuse
If the multi fuse is blown, it must be removed as follows: 1. Turn off the engine. 2. Disconnect the negative battery cable. 3. Remove the fuse panel on the right side in the engine compartment. 4. Remove the nuts shown in the picture above. 5. Replace the fuse with a new one of the s ...

© 2017-2024 www.kceed.com