Inspection |
1. |
Measure the resistance between the terminals.
|
2. |
If the measured resistance is not within specification, the blower resistor
must be replaced. (After removing the resistor.)
|
Replacement |
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Disconnect the connector (A) and then remove the blower resistor (B)
after loosening the mounting screws.
|
3. |
Install in the reverse order of removal.
|
Kia Cee'd JD Service Manual: Dual Clutch Transmission(DCT) Components and components location
Components
1. Odd clutch actuator motor
2. Even clutch actuator motor
3. Input shaft speed sensor 2
4. Intput shaft speed sensor 1
5. Inhibitor switch
6. Manual control lever
7. Shift motor
8. Select motor
9. Filler plug
...
Kia Cee'd JD Service Manual: Relay Box (Passenger Compartment) Description and operation
Description
Smart Junction Box(SJB)
1.
General function : Interior Junction Box + some functions of BCM
It controls loads with CAN communication and IPS.
2.
Main function
–
Low speed C ...