Kia Cee'd: Blower / Blower Motor Repair procedures

Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Blower / Blower Motor Repair procedures

Inspection

1.	Connect the battery voltage and check the blower motor rotation.

2.	If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.

3.	If the problem is corrected, replace the blower motor.

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Disconnect the blower motor connector (A).

3.	Remove the blower motor (B) after loosening the mounting screws.

4.	Install in the reverse order of removal.

Blower Unit Repair procedures

Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater & blower assembly. (Refer to Heater - &q ...

Blower Resistor (Manual) Repair procedures

Inspection 1. Measure the resistance between the terminals. 2. If the measured resistance is not within specification, the blower resist ...

Other information:

: Stopping the Liftgate Movement. Liftgate Obstacle Detection
Stopping the Liftgate Movement Note: Do not apply sudden excessive force to the liftgate while it is in motion. This could damage the power liftgate and its components. Note: Selections will vary depending on region or options. You can stop the liftgate movement by doing any of the following: ...

Kia Cee'd JD Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. ...