Kia Cee'd: Blind Spot Detection system / Blind Spot Detection Switch Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Blind Spot Detection system / Blind Spot Detection Switch Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the lower crash pad switch assembly (A) after loosening screws.

Inspection
1.
Remove the lower crash pad switch assembly.

2.
Connect the battery voltage to terminals 3 and the ground to terminal 4.
3.
Measure the voltage between terminals 4 and 2 at each position.
[Switch Position]
 
Position No.
Rotation
Voltage (V) (±5%)
0

10.85
1
15°
9.78
2
30°
9.17
3
45°
8.55
4
60°
7.94
5
75°
7.32
6
90°
6.71

4.
If the voltage is not as specified, replace the head lamp leveling switch.
Blind Spot Detection Switch Components and components location
Circuit Diagram ...

Blind Spot Detection Indicator Components and components location
Components ...

Other information:

Kia Cee'd JD Service Manual: Clutch Actuator Motor 2 (Even Gear) Specifications
Specification Clutch Actuator Motor 2 (Even Gear) ▷ Specification   Item  Specifications Operating condition (°C) °F (20) 68 Output resistance (mΩ)  48 ± 7% ...

Kia Cee'd JD Service Manual: Blower Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater & blower assembly. (Refer to Heater - "Heater Unit") 3. Separate the blower unit from the heater un ...

© 2017-2025 www.kceed.com