Kia Cee'd: Blind Spot Detection system / Blind Spot Detection Indicator Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Blind Spot Detection system / Blind Spot Detection Indicator Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mirror (A) from the mirror holder.

  
Be careful not to be damage the fixing clip (A).

3.
Disconnect the heating connectors (A) and BSD indicator connector (B) from the mirror.

Installation
1.
Connect the mirror heater connector and BSD indicator connector.
2.
Install the mirror.
3.
Connect the negative (-) battery terminal.
Inspection
1.
Verify that the mirror operates properly as shown in the below table.

BSD warning lamp

Blind Spot Detection Indicator Components and components location
Components ...

Emergency Call System
...

Other information:

Kia Cee'd JD Owners Manual: Using Voice Recognition
Starting Voice Recognition Shortly press the key on the steering wheel Say a command. If voice recognition is in [Normal Mode], then the system will say “Please say a command. Beep~” If voice recognition is in [Expert Mode], then the system will only say a “Beep~” To ...

Kia Cee'd JD Service Manual: Description and operation
Description The ECM (Electro Chromatic inside rear view Mirror) is for dimming the reflecting light from a vehicle behind at night, Preventing glare from the light. The forward facing sensor detects brightness of the surroundings, while the rearward looking sensor detects th ...

© 2017-2025 www.kceed.com