Kia Cee'd: Driveshaft Assembly / BJ Boot Repair procedures

Kia Cee'd JD Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Repair procedures

Replacement

1.	Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”)

2.	Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”)

3.	Remove the Dynamic damper. (Refer to Driveshaft Assembly - “Dynamic Damper”)

4.	Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.	Remove the BJ boot.

Install in the reverse order of removal.

•	Do not disassemble the BJ assembly.

•	Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.

•	The boot band should be replaced with a new one.

BJ Boot Components and components location

Components 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boo ...

Rear Axle Assembly / Rear Hub - Carrier

...

Other information:

: Distance Alert. Automatic Emergency Braking
Distance Alert What Is Distance Alert The system alerts you with a warning lamp if the distance to the vehicle ahead is small. Note: The warning lamp does not illuminate if cruise control or adaptive cruise control is active. Adjusting the Sensitivity of Distance Alert To adjust the sensitivity ...

Kia Cee'd JD Service Manual: Starter Specifications
Specification Starter [Non-ISG type] Item Specification Rated voltage 12 V, 1.2 kW The number of pinion teeth 10 Performance [No-load, 11 V] Ampere ...