Kia Cee'd: Manual Transaxle System / Back-up Lamp Switch Repair procedures

Kia Cee'd JD Service Manual / Manual Transaxle System / Manual Transaxle System / Back-up Lamp Switch Repair procedures

Inspection

1.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")

2.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

3.	Disconnect the back up lamp switch connector (A).

Check the continuity between power terminal and signal terminal.

Specification : Approx. below 1Ω

Removal

1.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")

2.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

3.	Disconnect the back up lamp switch connector (A).

Remove the back up lamp switch (A).

Tightening torque :

39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

Installation

1.	Install in the reverse order of removal.

The back-up lamp switch must be replaced with new one. (Do not reuse it.)

Back-up Lamp Switch Description and operation

Description • Detects the shift operation to the reverse gear. • When the transaxle is in the reverse condition, the reverse shift r ...

Neutral Switch Specifications

Specifications Item Specified Type ON/OFF Operation condition Neutral position ...

Other information:

Kia Cee'd JD Owners Manual: Paddle shifter
The paddle shifter is available when the shift lever is in the D (Drive) position or the sports mode. With the shift lever in the D position The paddle shifter will operate when the vehicle speed is more than 10km/h. Pull the [+] or [-] paddle shifter once to shift up or down one gear a ...

Kia Cee'd JD Service Manual: Components and components location
Component Location 1. Even clutch actuator motor 2. Input shaft speed sensor 2 3. Intput shaft speed sensor 1 4. Gear Actuator 5. Inhibitor switch 6. Odd clutch actuator motor 7. Select motor 8. Shift motor 9. Manual control ...