Kia Cee'd: AVN System / AVN Head Unit Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / AVN System / AVN Head Unit Repair procedures

Removal
AVN Head Unit
  
•
Take care not to scratch the center fascia panel and related parts.
•
Ejact all the disc before removing the AVN head unit to prevent damaging the CD player's load mechanism.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
•
Put on gloves to protect your hands.
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia panel (A).

3.
Disconnect the start/stop button connector (A).

4.
Remove the ANV head unit (A) after loosening 4 screws.

5.
Remove the AVN head unit connectors and cables (A).

  
–
If CD does not eject, don't try to remove it.
–
The player may be damaged.
–
Therefore, contact a service shop for repairs.
Installation
1.
Connect the AVN head unit connectors and cables.
2.
Install the AVN head unit.
3.
Install the center fascia panel.
4.
Connect the negative (-) battery terminal.
  
Make sure the AVN Head unit connectors are plugged in properly and the antenna cable is connected properly.
AVN Head Unit Components and components location
Components Connector Pin Information   No. Connector A Connector B Connector C 1 Rear left spe ...

Roof Antenna Components and components location
Components ...

Other information:

Kia Cee'd JD Owners Manual: Headlamp delay function
The headlamps (and/or taillights) remain on for same minutes (Type A: 20 minutes, Type B: 5 minutes) after the ignition key is removed or turned to the ACC or LOCK position. However, if the driver’s door is opened and closed, the headlights are turned off after 15 seconds. The headli ...

Kia Cee'd JD Service Manual: Rain Sensor Repair procedures
Inspection Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the rain sensor input signal. 2. If the wiper switc ...

© 2017-2026 www.kceed.com