Kia Cee'd: Auto Lighting Control System / Auto Light Sensor Repair procedures
Kia Cee'd JD Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor Repair procedures
| Inspection |
In the state of IGN1 ON, when multifunction switch module detects auto light
switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto light sensor's input.
The auto light control doesn't work if the pin sunlight supply (5V regulated
power from Ignition 1 power to sunlight sensor) is in short circuit with the
ground.
If IGN1 ON, The BCM monitors the range of this supply and raises up a failure
as soon as the supply’s voltage is out of range. Then this failure occurs and
as long as this is present, the head lamp must be turned on without taking care
about the sunlight level provided by the sensor.
This is designed to prevent any head lamp cut off when the failure occurs during
the night.
| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the auto light sensor (A) from crash pad upper side by using
screw (-) driver.
|
| 3. |
Remove the auto light connector (B).
|
| Installation |
| 1. |
Reconnect the auto light connector.
|
| 2. |
Install the auto light sensor.
|
Schematic diagrams
Circuit Diagram
...
Other information:
Kia Cee'd JD Owners Manual: Scheduled maintenance service
Follow Normal Maintenance Schedule
if the vehicle is usually operated where
none of the following conditions apply. If
any of the following conditions apply, follow
Maintenance Under Severe Usage
Conditions.
Repeated driving short distance of less
than 8 km (5 miles) in normal tempe ...
Kia Cee'd JD Owners Manual: Driving in the rain
Rain and wet roads can make driving
dangerous, especially if you’re not prepared
for the slick pavement. Here are a
few things to consider when driving in the
rain:
A heavy rainfall will make it harder to
see and will increase the distance
needed to stop your vehicle, so slow
...
© 2017-2025 www.kceed.com
