Kia Cee'd: Troubleshooting / Auto Defogging Sensor Repair procedures

Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the auto defogging sensor cover (A) by pulling it out.

3.
Disconnect the connector (A) and then remove the auto defogging sensor (B).

4.
Install in the reverse order of removal.
Auto Defogging Sensor Description and operation
Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air condit ...

Cluster Ionizer Description and operation
Description The cluster ionizer makes disinfection and decomposition of bad smell from the air-conditioner or inflow air. And it cleans the inside air of a vehicle. When runni ...

Other information:

Kia Cee'd JD Service Manual: General information
General Service Information Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work.    The support rod must be inserted into the hole near the edge of the ...

Kia Cee'd JD Owners Manual: Engine compartment fuse panel (for diesel engine)
✽ NOTICE The actual fuse/relay panel label may differ from equipped items. Engine compartment main fuse panel (for gasoline engine MPI, GDI) Engine compartment main fuse panel (for gasoline engine T-GDI) Engine compartment main fuse panel (for diesel engine) ...

© 2017-2026 www.kceed.com