Kia Cee'd: Adaptive Front Lighting System / Adaptive Front Lighting System Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Adaptive Front Lighting System / Adaptive Front Lighting System Repair procedures

Removal
AFLS Unit
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Remove the AFLS unti (A) after removing connector and nuts (2EA)
[LHD]

[RHD]

Installation
AFLS Unit
1.
Install the AFLS unit after connecting the connector.
2.
Install the crash pad lower panel.
3.
Install the heater and A/C controller.
4.
Install the crash pad center garnish.
5.
Connect the negative (-) battery terminal.
Adaptive Front Lighting System Description and operation
Description AFLS Unit(ECU) AFLS located in Cockpit Module is provided information of vehicle (steering wheel signal,vehicle speed, inclination of vehicle). Based on provide ...

Height Sensor Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Disconnect the head lamp height sensor connector. 3. ...

Other information:

: Changing the Remote Control Battery - Vehicles With: Push Button Start
WARNING: Keep batteries away from children to prevent ingestion. Failure to follow this instruction could result in personal injury or death. If ingested, immediately seek medical attention. WARNING: If the battery compartment does not securely close, stop using the remote control and replac ...

Kia Cee'd JD Owners Manual: Operating conditions
To operate: Press the BSD switch with the Ignition switch in the ON position. The indicator on the BSD switch will illuminate. When the vehicle speed exceeds 30 km/h (20 mph), the system will be activated. To cancel: Press the BSD switch again. The indicator on the switch will go off. W ...

© 2017-2026 www.kceed.com