Kia Cee'd: Engine Control System / Accelerator Position Sensor (APS) Repair procedures

Kia Cee'd JD Service Manual / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Repair procedures

Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

2.	Turn the ignition switch ON.

Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

Specification: Refer to “Specification”

Removal

1.	Turn the ignition switch OFF and disconnect the negative (-) battery cable.

2.	Disconnect the accelerator position sensor connector (A).

3.	Remove the installation bolt (B) and nuts (C), and then remove the accelerator pedal module.

Installation

Installation is reverse of removal.

Accelerator pedal module installation nut:

12.7 ~ 19.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

Accelerator pedal module installation bolt:

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Accelerator Position Sensor (APS) Schematic diagrams

Circuit Diagram ...

Injector Description and operation

Description The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fue ...

Other information:

Kia Cee'd JD Service Manual: CVVT & Camshaft Description and operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load. By controlling CVVT, the valve over-lap or under-lap ...

Kia Cee'd JD Service Manual: Troubleshooting
Troubleshooting Symptom Possible cause Remedy Tachometer does not operate Memory2 fuse (10A) blown Check for short and replace fuse CAN line faulty Check the EMS ...