Kia Cee'd: Engine Control System / Accelerator Position Sensor (APS) Description and operation

Kia Cee'd JD Service Manual / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Description and operation

Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line. The second sensor monitors the first sensor and its output voltage is half of the first one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the diagnostic system judges that it is abnormal.

Rail Pressure Sensor (RPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine spee ...

Accelerator Position Sensor (APS) Specifications
Specification   Accelerator Position Output Voltage (V) [Vref=5V] APS1 APS2 C.T 0.7 ~ 0.8 ...

Other information:

: Wipers
Wiper Precautions Do not operate the wipers on a dry windshield. This could scratch the glass or damage the wiper blades. Use the windshield washers before wiping a dry windshield. Fully defrost the windshield before you switch the windshield wipers on. Switch the windshield wipers off before ...

Kia Cee'd JD Service Manual: Components and components location
Components   1. Blind Spot Detection (BSD) Unit 2. BSD switch 3. BSD warning lamp 4. Cluster ...

© 2017-2026 www.kceed.com