Kia Cee'd: Troubleshooting / A/C Pressure Transducer Repair procedures

Inspection
1.
Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”.

2.
Inspect the voltage value whether it is sufficient to be regular value or not.
Vout = 0.00878835 * P + 0.37081095
3.
If the measured voltage value is not within the specification, replace the A/C pressure transducer.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/charging station.
3.
Disconnect the A/C pressure transducer connector (A).

4.
Remove the A/C pressure transducer (A).
Tightening torque:
10.0 ~ 12.0 N.m (1.02~ 1.22 kgf.m, 7.4~8.8 lb-ft)

  
Be careful not to bend the liquid & suction pipe.
5.
Install in the reverse order of removal.

  
When installing, replace it with a new O-ring (A).
A/C Pressure Transducer Description and operation
Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU cont ...

Evaporator Temperature Sensor Description and operation
Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by exc ...

Other information:

Kia Cee'd JD Owners Manual: Sliding the sunroof
When the sunshade is closed If you pull the sunroof control lever backward, the sunshade will slide all the way open then the sunroof glass will slide all the way open. To stop the sunroof movement at any point, pull or push the sunroof control lever momentarily. When the sunshade is o ...

Kia Cee'd JD Service Manual: Head Lamps Components and components location
Component   1. Head lamp assembly lens & housing 2. Head lamp low beam bulb 3. Turn signal lamp bulb 4. Position lamp bulb 5. Head lamp high beam bulb 6. Dust cap(High) 7. Dust cap(Low)   1. Head l ...

© 2017-2023 www.kceed.com