| Troubleshooting |
| Ignition System |
|
Symptom |
Suspect Area |
Remedy |
|
Engine will not start or is hard to start (Cranks OK) |
Ignition lock switch |
Inspect ignition lock switch, or replace as required |
|
Ignition coil |
Inspect ignition coil, or replace as required |
|
|
Spark plugs |
Inspect spark plugs, or replace as required |
|
|
Ignition wiring disconnected or broken |
Repair wiring, or replace as required |
|
|
Rough idle or stalls |
Ignition wiring |
Repair wiring, or replace as required |
|
Ignition coil |
Inspect ignition coil, or replace as required |
|
|
Engine hesitates/poor acceleration |
Spark plugs and spark plug cables |
Inspect spark plugs / cable, or replace as required |
|
Ignition wiring |
Repair wiring, or replace as required |
|
|
Poor mileage |
Spark plugs and spark plug cables |
Inspect spark plugs / cable, or replace as required |
| Charging System |
|
Symptom |
Suspect Area |
Remedy |
|
Charging warning indicator does not light with ignition switch "ON" and engine off. |
Fuse blown |
Check fuses |
|
Light burned out |
Replace light |
|
|
Wiring connection loose |
Tighten loose connection |
|
|
Electronic voltage regulator |
If light turns off, replace voltage regulator. |
|
|
Charging warning indicator does not go out with engine running. (Battery requires frequent recharging) |
Drive belt loose or worn |
Adjust belt tension or replace belt |
|
Battery cable loose, corroded or worn |
Inspect cable connection, repair or replace cable |
|
|
Electronic voltage regulator or alternator |
If light turns off, replace voltage regulator or alternator |
|
|
Wiring |
Repair or replace wiring |
|
|
Overcharge |
Electronic voltage regulator |
If light turns off, replace voltage regulator. |
|
Voltage sensing wire |
Repair or replace wiring |
|
|
Discharge |
Drive belt loose or worn |
Adjust belt tension or replace belt |
|
Wiring connection loose or short circuit |
Inspect wiring connection, repair or replace wiring |
|
|
Electronic voltage regulator or alternator |
If light turns off, replace voltage regulator or alternator |
|
|
Poor grounding |
Inspect ground or repair |
|
|
Worn battery |
Replace battery |
| Starting System |
|
Symptom |
Suspect Area |
Remedy |
|
Engine will not crank |
Battery charge low |
Charge or replace battery |
|
Battery cables loose, corroded or worn out |
Repair or replace cables |
|
|
Transaxle range switch (Vehicle with automatic transaxle only) |
Refer to AT group-automatic transaxle |
|
|
Fuse blown |
Replace fuse |
|
|
Starter motor faulty |
Replace |
|
|
Ignition switch faulty |
Replace |
|
|
Engine cranks slowly |
Battery charge low |
Charge or replace battery |
|
Battery cables loose, corroded or worn out |
Repair or replace cables |
|
|
Starter motor faulty |
Replace |
|
|
Starter keeps running |
Starter motor faulty |
Replace |
|
Ignition switch |
Replace |
|
|
Starter spins but engine will not crank |
Short in wiring |
Repair or replace wiring |
|
Pinion gear teeth broken or starter motor |
Replace |
|
|
Ring gear teeth broken |
Replace fly wheel or torque converter |
Specifications
Special service toolsKia Cee'd JD Service Manual: Blind Spot Detection Unit" Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
3.
Remove the BSD unit (A) after loosening the mounting nu ...
Kia Cee'd JD Service Manual: Rear Seat Assembly Repair procedures
Replacement
1.
After loosening the mounting bolts and then push it up and remove the
rear seat cushion assembly (A).
Tightening torque :
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
[5Door, ...