Kia Cee'd: Starting System / Starter Relay Repair procedures

Kia Cee'd JD Service Manual / Engine Electrical System / Starting System / Starter Relay Repair procedures

Inspection
1.
Disconnect the battery negative terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay(A).

4.
Using an ohmmeter, check that there is continuity between each terminal.
 
Terminal
Continuity
30 - 87
NO
85 - 86
YES

5.
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.

6.
If there is no continuity, replace the starter relay.
7.
Install the starter relay.
8.
Install the fuse box cover.
Starter Repair procedures
Removal 1. Disconnect the battery negative terminal. 2. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical ...

Cruise Control System
...

Other information:

Kia Cee'd JD Service Manual: Crankshaft Position Sensor (CKPS) Repair procedures
Inspection 1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” Removal 1. Turn the ignition switch OFF and disconnect the battery negative ...

Kia Cee'd JD Service Manual: Description and operation
Description BSD is a system that uses two magnetic wave radar sensors attached on the rear panel to measure the distance from the following vehicles and provides the sensing and (visual and auditory) alarm of any vehicle coming into the blind spot. – ...

© 2017-2026 www.kceed.com