Kia Cee'd: Body Side Molding / Roof Garnish Repair procedures

Replacement
[General Type]
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
  
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the roof garnish (A).

2.
Install in the reverse order of removal.
  
Replace any damaged clips.
[Panoramaroof Type]
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
  
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the roof garnish (A).

2.
Install in the reverse order of removal.
  
Replace any damaged clips.
Body Side Molding
...

Rear Spoiler Repair procedures
Replacement    • When prying with a flat-tip screwdriver, wrap it with protective ...

Other information:

Kia Cee'd JD Owners Manual: Owner maintenance schedule
When you stop for fuel: Check the engine oil level. Check coolant level in coolant reservoir. Check the windshield washer fluid level. Look for low or under-inflated tires. Check the radiator and condenser. Check if the front of the radiator and condenser are clean and not block ...

Kia Cee'd JD Service Manual: Injector Troubleshooting
Signal Waveform The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side (ground side) of the #1 injector and the bottom waveform is from th ...

© 2017-2025 www.kceed.com