Kia Cee'd: Engine Room Under Cover / Repair procedures

Removal and Installation
1.
Remove the engine room under cover (A).
Tightening torque:
3.9 ~ 5.9N.m (0.4 ~ 0.6kgf.m, 2.9 ~ 4.3lb-ft)

2.
Installation is reverse order of removal.
Components and components location
Components   1. Under cover front pannel. 2. Engine room LH under cover 3. Engine room RH under cover ...

Engine Mounting Components and components location
Components   1. Transaxle mounting bracket 2. Roll road bracket 3. Engine mounting bracket 4. Engine mounting support bracket ...

Other information:

Kia Cee'd JD Service Manual: Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV terminals 1 and 2. 4. Check that the resistance is within ...

: Checking the Wiper Blades. Replacing the Front Wiper Blades. Replacing the Rear Wiper Blades
Checking the Wiper Blades Run the tip of your fingers over the edge of the blade to check for roughness. Replacing the Front Wiper Blades Lift the wiper arm and then press the wiper blade locking buttons together.Note: Do not hold the wiper blade to lift the wiper arm. Note: Make sure th ...

© 2017-2026 www.kceed.com