Kia Cee'd: Fuel Filler Door / Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Fuel Filler Door / Repair procedures

Replacement

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Put on gloves to protect your hands.

1.	Remove the fuel filler door release actuator.

2.	Open the fuel filler door.

After loosening the mounting screws, then remove the fuel filler door packing (A).

Tightening torque :

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

4.	Pull out the fuel filler door open switch (A) outside of the trunk by pushing in the lock pins located inside the trunk.

5.	Pull out the fuel filler door cable (A) outside of the trunk by pushing in the lock pins located inside the trunk.

Remove the fuel filler door housing (A).

•	Pull out from inside of the packing part (B) When removing the fuel filler door housing.

Install in the reverse order of removal.

•	Make sure the fuel filler door locks/unlocks and opens/closes properly.

•	Replace any damaged clips.

Components and components location

Component Location 1. Fuel filler door ...

Front Door

...

Other information:

Kia Cee'd JD Service Manual: Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection. &nb ...

Kia Cee'd JD Service Manual: Inhibitor Switch Description and operation
Description The inhibitor switch is mounted on the transmission case. It includes the electric switch plate circuit and is directly connected with the transmission lever via transmission cable. When the driver shifts the transmission lever, the contact point on the switch ...