Kia Cee'd: Rear Parking Assist System / Rear Parking Assist System Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the console upper tray complete.
(Refer to Body - "Floor Console Assembly")
|
| 3. |
Disconnect the connector (A).
|
| 4. |
Loosen screws after connecting the connector.
Remove the parking assist system switch (A).
|
| Installation |
| 1. |
Install the parking assist system switch and the console upper tray
complete.
|
| 2. |
Connect the negative (-) battery terminal.
|
Parking Assist Sensor Repair procedures
Removal
[Rear Bumper]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper cover.
(Refer to Body - &q ...
Other information:
Kia Cee'd JD Owners Manual: Non-operating condition
The sensors are located inside of the
rear bumper.
Always keep the rear bumper clean for
the system to work properly.
WARNING
The warning light on the outside
rearview mirror will illuminate
whenever a vehicle is detected at
the rear side by the system.
To avoid accidents, do ...
Ford Escape 2020-2022 Owners Manual: Garage Door Opener Limitations. Programming the Garage Door Opener to Your Hand-Held Transmitter
Garage Door Opener Limitations
Canadian radio-frequency laws require
transmitter signals to time-out (or quit)
after several seconds – which may not be
long enough for HomeLink to pick up the
signal.
U.S. gate operators time-out in the same
manner.
Note: If programming a garage door opener
o ...
