| Replacement |
| 1. |
Pull down rear door window glass by pressing the power window glass
switch.
|
| 2. |
After loosening the mounting screws, then remove the rear door belt
outside weatherstrip (A).
|
| 3. |
Install in the reverse order of removal.
|
Rear Door Latch Repair procedures
Rear Door Belt Inside Weatherstrip Repair procedures: Introduction
About This Publication
WARNING: Driving while distracted
can result in loss of vehicle control, crash
and injury. We strongly recommend that
you use extreme caution when using any
device that may take your focus off the
road. Your primary responsibility is the
safe operation of your vehicle. W ...
: Pre-Collision Assist – Troubleshooting
Pre-Collision Assist – Information Messages
Pre-Collision Assist – Frequently Asked Questions
Camera Troubleshooting
The windshield in front of the camera
is dirty or obstructed.
Clean the outside of the windshield in
front of the camera.
The windshield in front of the camera
is clean, but t ...