Kia Cee'd: Brake system / Hill-start assist control (HAC)
A vehicle has the tendency to slip back on a steep hill when it starts to go after stopping. The Hill-start Assist Control (HAC) prevents the vehicle from slipping back by operating the brakes automatically for about 1~2 seconds. The brakes are released when the accelerator pedal is depressed or after about 1~2 seconds.
WARNING
The HAC is activated only for about 1~2 seconds, so when the vehicle is starting off always depress the accelerator pedal.
✽ NOTICE
- The HAC does not operate when the transaxle shift lever is in the P (Park) or N (Neutral) position.
- The HAC activates even though the ESC is off but it does not activate when the ESC has malfunctioned.
Malfunction indicator
The VSM can be deactivated even if you
don’t cancel the VSM operation by pressing
the ESC OFF button. It indicates that
a malfunction has been detected somewhere
in the EPS (Electronic Power ...
Emergency Stop Signal (ESS)
The Emergency Stop Signal system
alerts the driver behind by blinking the
stop light when the vehicle is braked rapidly
and severely.
The system is activated when:
The vehicle suddenly stop ...
Other information:
Kia Cee'd JD Owners Manual: To cancel cruise control, do one
of the following
Depress the brake pedal.
Depress the clutch pedal if equipped
with a manual transaxle.
Shift into N (Neutral) if equipped with
an automatic transaxle.
Press the O (Cancel) button located on
the steering wheel.
Decrease the vehicle speed lower than
the memory speed by 20 km/h ...
Kia Cee'd JD Service Manual: PTC Heater (Gasoline Engine) Repair procedures
Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation with the confirmation logic below :
1.
Entering
(1)
Set the Floor mode and maximum heating position.
(2)
...
