| Inspection |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
|
| 2. |
Disconnect the fuel pressure regulator valve connector.
|
| 3. |
Measure resistance between the fuel pressure regulator valve terminals
1 and 2.
|
| 4. |
Check that the resistance is within the specification.
|
Fuel Pressure Control Valve Schematic diagrams
ISG (Idle Stop & Go) Components and components location: Doors and Locks – Troubleshooting
Doors and Locks – Warning Lamps
Door Ajar Warning Lamp
It illuminates when you switch
the ignition on and remains on if
any door or the hood is open.
Doors and Locks – Information Messages
Doors and Locks – Frequently Asked Questions
Can accessories such as steps or handles be used with th ...
Kia Cee'd JD Service Manual: Accelerator Position Sensor (APS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Specificati ...