Kia Cee'd: Front Door / Front Door Module Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Front Door / Front Door Module Repair procedures

Replacement

1.	Remove the front door window glass. (Refer to Front Door - "Front Door Window Glass")

2.	Remove the front door outside handle. (Refer to Front Door - "Front Door Outside Handle")

3.	Disconnect the outside rear view mirror connector (A).

4.	Loosen the outside handle base mounting bolt (A).

5.	Loosen the front door latch (B) mounting screws.

After loosening the mounting bolts, then remove the front door module (A).

Tightening torque :

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

7.	Disconnect the front door module mounting clip (B).

8.	Disconnect the connectors and front door module wiring harness (A).

Install in the reverse order of removal.

•	The area of whole parts should be applied with sufficient grease.

•	Make sure connectors are connected properly and each rod is connected securely.

•	Make sure the door locks/unlocks and opens/closes properly.

Front Door Module Components and components location

Component Location 1. Front door module ...

Front Door Outside Handle Components and components location

Component Location 1. Front door outside handle ...

Other information:

Kia Cee'd JD Owners Manual: Electronic Stability Control (ESC) indicator
The ESC indicator will illuminate when the ignition switch is turned ON, but should go off after approximately 3 seconds. When the ESC is on, it monitors the driving conditions. Under normal driving conditions, the ESC indicator will remain off. When a slippery or low traction condit ...

Kia Cee'd JD Service Manual: Tail Gate Trim Repair procedures
Replacement • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. ...