Kia Cee'd: ESP(Electronic Stability Program) System / ESP OFF Switch Description and operation
| Description |
| • |
1st stage
The ESP engine control function will stop when the ESP OFF indicator
on the cluster turns on by pressing the ESP OFF button for 0.15 second.
(The brake control function works normally.)
|
| • |
2nd stage
The ESP engine and brake control function will stop when the ESP OFF
indicator on the cluster turns on by pressing the ESP OFF button for
3 seconds.
|
Yaw-rate and Lateral G Sensor Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Pull the passenger seat towards the front till ...
ESP OFF Switch Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad center lower panel.
(Refer to Crash Pad - &quo ...
Other information:
Kia Cee'd JD Service Manual: High Pressure Fuel Pump Repair procedures
Removal
In case of removing the high pressure fuel pump, high pressure fuel
pipe, delivery pipe, and injector, there may be injury caused by leakage
of the high pressure fuel. So don’t do any repair w ...
: Blind Spot Information System Requirements. Switching Blind Spot Information System On and Off
Blind Spot Information System Requirements
Blind spot information system turns on
when all the following occur:
You start your vehicle.
You shift into drive (D).
The vehicle speed is greater than
6 mph (10 km/h).
Switching Blind Spot Information System On and Off
To switch blind spot informa ...
