Kia Cee'd: Clutch Switch / Description and operation

Description
Clutch switch is connected to clutch pedal and transmits clutch operating state to ECM.
When clutch pedal is depressed during driving, engine load changes from loaded to none loaded condition. However, ECM regards vehicle to be loaded becuase VSS signal is still inputted to it. therefore, ECM controls none loaded engine with the condition suitable for loaded engine.
Accordingly, optimum fuel injection control is not performed then, RPM becomes unstable and smoke is produced.
Clutch operation is detected through clutch switch signal. This signal enables ECM to cope with instant change of load condition.
Besides, clutch switch signal is used to detect engaged gear with vehicle speed and engine speed.

Clutch Switch
...

Specifications
Specifications   Item Specifications Working voltage  DC 12V  Operating force 14.7 ± ...

Other information:

: Voice Settings Commands
You can say the following commands to access the voice settings: You can use the volume control to adjust the volume of the system voice prompts. While prompt is active, adjust the volume control up or down to your desired setting. Note: Depending on the current climate control settings, the f ...

Kia Cee'd JD Service Manual: IMS (Integrated Memory System) module Repair procedures
Removal 1. Remove the negative (-) battery terminal. 2. Remove the driver seat in the car. (Refer to Body - "Front Seat Assembly") 3. Remove the IMS module (A) after loosening 3 screws i ...

© 2017-2026 www.kceed.com