Kia Cee'd: Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures
| 1. |
Check signal waveform of CKPS and CMPS using a GDS.
|
Specification: Refer to “Waveform”
|
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
|
| 2. |
Disconnect the crankshaft position sensor connector (A) and remove the
sensor (B) after removing the installation bolt.
|
| • |
Install the component with the specified torques.
|
| • |
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
|
|
| • |
Apply the engine oil to the O-ring.
|
|
| • |
Insert the sensor in the installation hole and be careful not
to damage.
|
|
| 1. |
Installation is reverse of removal.
|
Crankshaft position sensor installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
Circuit Diagram
[NON-ISG]
[ISG]
...
Description
Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position
by using a hall element.
It is related with Crankshaft Position Sensor (CKPS) and ...
Crankshaft Position Sensor (CKPS) Schematic diagrams
Camshaft Position Sensor (CMPS) Description and operation