Kia Cee'd: Crash Pad / Center Fascia Panel Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Crash Pad / Center Fascia Panel Repair procedures

Replacement
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
  
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the center fascia panel (A).

2.
Disconnect the start/stop button connector (A).

3.
Install in the reverse order of removal.
  
Make sure the connector are connected in properly.
Replace any damaged clips.
Center Fascia Panel Components and components location
Component Location   1. Center fascia panel ...

Crash Pad Lower Panel Components and components location
Component Location   1. Crash pad lower panel ...

Other information:

Kia Cee'd JD Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. ...

Kia Cee'd JD Owners Manual: Inner panel fuse replacement
1. Turn the ignition switch and all other switches off. 2. Open the fuse panel cover. 3. Pull the suspected fuse straight out. Use the removal tool provided in the engine compartment fuse panel. 4. Check the removed fuse; replace it if it is blown. 5. Push in a new fuse of the same r ...

© 2017-2026 www.kceed.com