Kia Cee'd: Adaptive Front Lighting System / Adaptive Front Lighting System Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Adaptive Front Lighting System / Adaptive Front Lighting System Repair procedures

Removal

AFLS Unit

1.	Disconnect the negative (-) battery terminal.

2.	Remove the glove box housing. (Refer to Body - "Glove Box Housing")

3.	Remove the AFLS unti (A) after removing connector and nuts (2EA) [LHD] [RHD]

Installation

AFLS Unit

1.	Install the AFLS unit after connecting the connector.

2.	Install the crash pad lower panel.

3.	Install the heater and A/C controller.

4.	Install the crash pad center garnish.

5.	Connect the negative (-) battery terminal.

Adaptive Front Lighting System Description and operation

Description AFLS Unit(ECU) AFLS located in Cockpit Module is provided information of vehicle (steering wheel signal,vehicle speed, inclination of vehicle). Based on provide ...

Height Sensor Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Disconnect the head lamp height sensor connector. 3. ...

Other information:

Kia Cee'd JD Owners Manual: Multi fuse
If the multi fuse is blown, it must be removed as follows: 1. Turn off the engine. 2. Disconnect the negative battery cable. 3. Remove the fuse panel on the right side in the engine compartment. 4. Remove the nuts shown in the picture above. 5. Replace the fuse with a new one of the s ...

Kia Cee'd JD Service Manual: Ambient Temperature Sensor Description and operation
Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature. The sensor output will be used ...