| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Disconnect the accelerator position sensor connector (A).
|
| 3. |
Remove the installation bolt (B) and nuts (C), and then remove the accelerator
pedal module.
|
| Installation |
| 1. |
Installation is reverse of removal.
|
Filler-Neck Assembly Repair procedures
Delivery Pipe Repair proceduresFord Escape 2020-2025 Owners Manual: Power Seats
Head Restraint Components
The front seat head restraints consists of:
An energy absorbing head
restraint.
Two steel stems.
Guide sleeve adjust and unlock
button.
Adjusting the Head Restraint
WARNING: Fully adjust the head
restraint before you sit in or operate your
vehicle. This will hel ...
Kia Cee'd JD Owners Manual: Battery recharging
Your vehicle has a maintenance-free,
calcium-based battery.
If the battery becomes discharged in a
short time (because, for example, the
headlights or interior lights were left on
while the vehicle was not in use),
recharge it by slow charging (trickle)
for 10 hours.
If the ba ...