Kia Cee'd: Engine Control System / Variable Intake Solenoid (VIS) Valve Repair procedures
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the VIS valve connector.
|
| 3. |
Measure resistance between VIS valve terminals 1 and 2.
|
Specification: Refer to "Specification"
|
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
|
| 2. |
Disconnect the variable intake solenoid valve connector (A).
|
| 3. |
Disconnect the vacuum hoses (B) from the valve.
|
| 4. |
Remove the installation bolt, and then remove the valve (C) from the
surge tank.
|
| • |
Install the component with the specified torques.
|
| • |
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
|
|
| • |
Use care to keep foreign material out of the valve.
|
|
| 1. |
Installation is reverse of removal.
|
Description
Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and
controls fuel flow flowing into the injectors in accordance with the ECM signal
calculat ...
Other information:
: Power Seats
Head Restraint Components
The front seat head restraints consists of:
An energy absorbing head
restraint.
Two steel stems.
Guide sleeve adjust and unlock
button.
Adjusting the Head Restraint
WARNING: Fully adjust the head
restraint before you sit in or operate your
vehicle. This will hel ...
Kia Cee'd JD Owners Manual: Transmitter precautions
✽ NOTICE
The transmitter will not work if any of
following occur:
The ignition key is in ignition switch.
You exceed the operating distance
limit (about 10 m [30 feet]).
The battery in the transmitter is
weak.
Other vehicles or objects may be
blocking the signal.
The weathe ...
Variable Intake Solenoid (VIS) Valve Schematic diagrams
Fuel Pressure Control Valve Description and operation