Kia Cee'd: Dual Clutch Transmission Assembly / Transmission Gear Oil Repair procedures
|
In principle, the transmission oil is maintenance-free, and no exchange
is required.
But it must be inspected and replenished every 4 years or 40,000 miles.
|
| 1. |
Park the vehicle on flat ground and turn off the engine.
|
| 2. |
Remove the oil filler plug (A), and check the oil state and oil level.

|
| 3. |
If the oil is dirty, loosen the oil drain plug (B) and drain the oil.
Then fill with new oil.

|
|
In principle, the Dual Clutch Transmission (DCT) oil is not changed
under normal driving conditions.
However, under harsh driving conditions, it must be changed every 80,000
miles.
Harsh driving conditions are as follows:
| • |
High frequency driving on rough roads (bumpy roads, sand and
gravel roads, snow-covered roads, and unpaved roads)
|
| • |
Frequent driving on mountain trails and inclines
|
| • |
In case the vehicle is used as a police vehicle, taxi, or for
commercial or towing purposes
|
| • |
Frequent high speed driving (over 170 km/h)
|
| • |
In case of driving 50% or more of the total mileage in hot temperatures
above 32°C and congested traffic
|
|
| 1. |
Remove the drain plug (A) and drain all the oil. Then replace the drain
plug.
|
Drain plug tightening torque:
58.8 ~ 78.4 N.m (6.0 ~ 8.0 kgf.m, 43.2 ~ 57.6 lb-ft)
|

|
The drain plug gasket must be replaced with a new one.
|
|
| 2. |
Remove the oil filler plug (A) and fill with approximately 1.9 liters
of new oil. Then replace the removed oil filler plug.

|
Specified Lubricant
Item
Specified lubricant
Capacity
Transmission oil
SAE 75W/85, API GL-4
Approx. ...
Other information:
Ford Escape 2020-2026 Owners Manual: Wireless Accessory Charging Module (If Equipped)
Argentina
Brazil
Djibouti
European Union EU
Ghana
Jamaica
Jordan
Malaysia
SQASI/TA/19/4129
Mauritania
Moldova
Morocco
Paraguay
2017-10-I-0000333
Serbia
Singapore
South Africa
South Korea
Taiwan, China
Ukraine
United Arab Emirates (U.A.E.)
United States
WARNING: Changes or
modific ...
Kia Cee'd JD Service Manual: Repair procedures
Diagnosis With GDS
1.
BSD system defects can be quickly diagnosed with the GDS. GDS operates
actuator quickly to monitor, input/output value and self diagnosis.
2.
Connect the cable of GDS to the data link connector in driver si ...