Kia Cee'd: Cruise Control system / To turn cruise control off, do one of the following
- Move the lever down (
). - Move the lever up (
). (If
you move
the lever up, the speed limit system will
turn on) - Turn the ignition off.
Both of these actions cancel cruise control operation. If you want to resume cruise control operation, repeat the steps provided in “To set cruise control speed” on the previous page.
To resume cruising speed at
more than approximately 30 km/h
(20 mph)
If any method other than the
button
was used to cancel cruising speed and
the system is still activated, the most
recent set speed will automatically
resume when the +RES switch is
push ...
Speed limit control system
You can set the speed limit when you do
not want to drive over a specific speed.
If you drive over the preset speed limit,
the warning system operates (set speed
limit will blink and chime wil ...
Other information:
Kia Cee'd JD Service Manual: Input Speed Sensor 1 Repair procedures
Inspection
Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor.
Removal
1.
Turn off the ignition switch and then disconnect the battery (-) cable.
2.
Remove the under cover.
3.
...
Kia Cee'd JD Owners Manual: How the system works
(Exit mode)
The Exit Mode operates in the below
condition:
When vehicle speed is below 5 km/h
the first time after the engine has been
started.
After parallel parking is completed with
the Smart Parking Assist System.
1. Activate the Smart Parking Assist
System
The shift lever should be p ...