Troubleshooting |
1. |
The lamp switch inputs can be checked using the GDS.
|
2. |
To check the input value of lamp switch, select option "Body Control
Module".
|
3. |
To consult the present input/output value of BCM, "Current DATA". It
provides information of BCM input/output conditions of power supply,
turn signal/brake lamp, headlamp, door, locks, outside mirror, wiper,
auto-light and transmitters etc.
|
4. |
To check the input value of lamp switch in force mode, select option
"Actuation Test".
|
Symptom |
Possible cause |
Remedy |
One lamp does not light (all exterior) |
Bulb burned out |
Replace bulb |
Socket, wiring or ground faulty |
Repair if necessary |
|
Head lamps do not light |
Bulb burned out |
Replace bulb |
Lighting switch faulty |
Check switch |
|
Wiring or ground faulty |
Repair if necessary |
|
Tail lamps and license plate lamps do not light |
Bulb burned out |
Replace bulb |
Lighting switch faulty |
Check switch |
|
Wiring or ground faulty |
Repair if necessary |
|
Stop lamps do not light |
Bulb burned out |
Replace bulb |
Stop lamp fuse (15A) blown |
Check for short and replace fuse |
|
Stop lamp switch faulty |
Adjust or replace switch |
|
Wiring or ground faulty |
Repair if necessary |
|
Stop lamps do not turn off |
Stop lamp switch faulty |
Repair or replace switch |
Instrument lamps do not light (Tail lamps light) |
Rheostat faulty |
Check rheostat |
Wiring or ground faulty |
Repair if necessary |
|
Turn signal lamp does not flash on one side |
Bulb burned out |
Replace bulb |
Turn signal switch faulty |
Check switch |
|
Wiring or ground faulty |
Repair if necessary |
|
Turn signal lamps do not light |
Bulb burned out |
Replace bulb |
Flasher unit faulty |
Check flasher unit |
|
Turn signal switch faulty |
Check switch |
|
Wiring or ground faulty |
Repair if necessary |
|
Hazard warning lamps do not light |
Bulb burned out |
Replace bulb |
Flasher unit faulty |
Check flasher unit |
|
Hazard switch faulty |
Check switch |
|
Wiring or ground faulty |
Repair if necessary |
|
Flasher rate too slow or too fast |
Lamps' wattages are smaller or larger than specified |
Replace lamps |
Flasher unit faulty |
Check flasher unit |
|
Back up lamps do not light |
Bulb burned out |
Replace bulb |
Back up lamp switch (M/T) faulty |
Check switch |
|
Transaxle range switch (A/T) faulty |
Check switch |
|
Wiring or ground faulty |
Repair if necessary |
|
Room lamp does not light |
Bulb burned out |
Replace bulb |
Room lamp switch faulty |
Check switch |
|
Wiring or ground faulty |
Repair if necessary |
|
Front fog lamps do not light |
Bulb burned out |
Replace bulb |
Front fog lamp switch faulty |
Check switch |
|
Wiring or ground faulty |
Repair if necessary |
|
Rear fog lamps do not light |
Bulb burned out |
Replace bulb |
Rear fog lamp switch faulty |
Check switch |
|
Wiring or ground faulty |
Repair if necessary |
|
Map lamp does not light |
Bulb burned out |
Replace bulb |
Map lamp switch faulty |
Check switch |
|
Wiring or ground faulty |
Repair if necessary |
|
Trunk room lamp does not light |
Bulb burned out |
Replace bulb |
Trunk room lamp switch faulty |
Check switch |
|
Wiring or ground faulty |
Repair if necessary |
Kia Cee'd JD Owners Manual: Fuel gauge
The fuel gauge indicates the approximate
amount of fuel remaining in the fuel
tank.
✽ NOTICE
The fuel tank capacity is given in
chapter 8.
The fuel gauge is supplemented by a
low fuel warning light, which will illuminate
when the fuel tank is nearly
empty.
On inclines or ...
Kia Cee'd JD Service Manual: Glove Box Housing Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with protective
tape, and apply protective tape around the related parts, to
prevent damage.
...