Inspection |
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the mode control actuator connector.
|
3. |
Verify that the mode control actuator operates to the defog mode when
connecting 12V to terminal 3 and grounding terminal 4.
Verify that the mode control actuator operates to the vent mode when
connected in reverse.
|
4. |
Connect the mode control actuator connector.
|
5. |
Turn the ignition switch ON.
|
6. |
Check the voltage between terminal 4 and 5.
Specification
With auto defogging activated
It will feedback the current position of the actuator to the controls.
|
7. |
If the measured voltage is not within specification, substitute with
a known-good mode control actuator and check for proper operation.
|
8. |
If the problem is corrected, replace the mode control actuator.
|
Replacement |
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
|
3. |
Remove the driver side shower duct (A) after loosening the screw.
|
4. |
Remove the brake pedal assembly.
(Refer to Brake System - " Brake Pedal")
|
5. |
Disconnect the connector (A) and then remove the mode control actuator
(B) after loosening the mounting screws.
|
6. |
Install in the reverse order of removal.
|
Kia Cee'd JD Service Manual: Heater Unit Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/recycling/charging station.
3.
When the engine is cool, drain the engine coolant from the radiato ...
Kia Cee'd JD Owners Manual: Category Menu
Within the iPod® Category menu, you
will have access to the ,
,
and features.
(1) : Displays the play screen
(2) : Moves to the iPod® root
category
screen
(3) : Moves to the previous
category
✽ NOTICE
If the search mode is accessed
while playing a song, the most
rece ...