Kia Cee'd: Rear Bumper / Rear Bumper Cover Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Cover Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	After loosening the mounting screws, then remove the rear combination lamp (A). [5Door] [3Door]

2.	Disconnect the rear combination lamp connector (A).

3.	After loosening the rear bumper side's mounting screws, then disconnect the side's.

4.	Loosen the rear bumper lower mounting clips.

5.	Loosen the rear bumper lower mounting bolts.

6.	Loosen the rear bumper upper mounting screw and clip.

7.	Remove the rear bumper cover (A).

8.	Disconnect the rear bumper main connector (A).

Install in the reverse order of removal.

•	Replace any damaged clips.

•	Make sure the connector is plugged in properly.

Rear Bumper Cover Components and components location

Component Location 1. Rear bumper cover ...

Rear Bumper beam Assembly Components and components location

Component Location 1. Rear bumper beam assembly ...

Other information:

Kia Cee'd JD Owners Manual: Instrument panel overview
1. Instrument cluster 2. Horn 3. Steering wheel audio control 4. Cruise control switch Speed limiter control switch Cluster display mode conversion switch 5. Driver’s air bag 6. Ignition switch or ENGINE START/STOP button 7. Hazard warning switch 8. Audio 9. Seat warmer 10. Centra ...

Kia Cee'd JD Service Manual: Accelerator Position Sensor (APS) Specifications
Specification Accelerator Position Output Voltage (V) [Vref=5V] APS1 APS2 C.T 0.7 ~ 0.8 0.29 ~ 0.46 W.O.T 3.85 ~ 4.35 1.93 ~ 2.18 ...