Inspection |
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the temperature control actuator connector.
|
3. |
Verify that the temperature control actuator operates to the warm position
when connecting 12V to terminal 3 and grounding terminal 4.
Verify that the temperature control actuator operates to the cool position
when connected in reverse.
|
4. |
Connect the temperature control actuator connector.
|
5. |
Turn the ignition switch ON.
|
6. |
Check the voltage between terminal 4 and 5.
Specification
It will feedback the current position of the actuator to the controls.
|
7. |
If the measured voltage is not specification, substitute with a known-good
temperature control actuator and check for proper operation.
|
8. |
If the problem is corrected, replace the temperature control actuator.
|
Replacement |
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
|
3. |
Remove the driver side shower duct (A) after loosening the screw.
|
4. |
Disconnect the connector (A) and then remove the temperature control
actuator (B) after loosening the mounting screws.
|
5. |
Install in the reverse order of removal.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the heater & blower assembly.
(Refer to Heater - "Heater Unit")
|
3. |
Separate the blower unit from the heater unit after loosening 3 screws.
|
4. |
Disconnect the connector (A) and then remove the temperature control
actuator (B) after loosening the mounting screws.
|
5. |
Install in the reverse order of removal.
|
Kia Cee'd JD Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Signal Waveform
[NON-ISG]
This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position
Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing
by using these signals.
Generally CkPS signal is used to dete ...
Kia Cee'd JD Service Manual: CVVT Oil Control Valve (OCV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within t ...